University of Utah Update: Chair Prints with Recycled PETG Filament – Filabot
University of Utah Update: Chair Prints with Recycled PETG Filament

3d recycling, 3d Recyling, Experiments, Filament, Recycling Filament, University of Utah binary Collab -

University of Utah Update: Chair Prints with Recycled PETG Filament

For the final project with the Design of University of Utah Digital Assemblies class, students were tasked with a chair design that incorporated recycled PETG filament, compounded with color pigments using the Filabot EX2, as a decorative/accent and/or a functional element. This week’s post puts a spotlight on one of the designs, produced by @trimurray19.

“With this design I intended to have the filament as an accent piece to the overall chair and highlight the form. I wanted the dowels to protrude from each side so filament could interweave between them. This allows for the filament to be seen from both side and front views. I was pleasantly surprised with the strength of the filament and its ability to be woven. It’s materiality allows it to be strong enough to weave and hold its shape without additional adhesives”

Click here to see all Filabot posts related to the University of Utah/ Binary collaboration.

Click here to see all Massive Dimension posts related to the University of Utah/ Binary collaboration.

 

Below are some photos from the experiments:

1. Half-scale model of Tristan Murphy_s rocking chair, incorporating recycled PETG filament as a decorative element

2. The design incorporated woven recycled PETG filament compounded and extruded using the Filabot EX2

3. Close-up on the woven detail


Leave a comment

Please note, comments must be approved before they are published