#TechTuesday: Filabot Dri-Air Sneak Peak!

#TechTuesday: Filabot Dri-Air Sneak Peak!

#FilamentFriday: Testing Your Filament Reading #TechTuesday: Filabot Dri-Air Sneak Peak! 1 minute Next #3DThursday: GPU Stands

Here it is! Some pictures of our latest product rolling out later next week. 

Moisture in pellets can cause many issues during extrusion such as bubbles, undersized filament, and breakage. It's not a good time. While all of Filabot brand pellets are pre-dried for your usage, if you are using other materials or experimenting with hybrids it's possible to have a moisture problem. This simple dryer will ensure moisture does not damage your pellets. We're pumped!


Check back on our social channels for the official launch of this new product! 

The Filabot Team

Leave a comment

All comments are moderated before being published.

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.