UPDATE: Extrusion Data File System - Updated June 2020

UPDATE: Extrusion Data File System - Updated June 2020

Additions to the 1.75mm sheets with HIPS and PETG+ added for setting.  For the first time a complete list of 2.85mm diameter settings for all of the current grades we have on the site as well as some old grades: HIPS, Jam ABS, and PETG+

Here are the updates:

  • Additions to the 1.75mm sheets with HIPS and PETG+ added for setting. 

  • For the first time a complete list of 2.85mm diameter settings for all of the current grades we have on the site as well as some old grades: HIPS, Jam ABS, and PETG+

All of these settings were tested using only the EX2 bundle with the addition of the Filameasure to verify the data.

We ran each test for a complete spool and then tested the material on our printer for multiple prints to get the full duration of if the filament works. 

You may download the updated Extrusion Data File System spreadsheet below:

Leave a comment

All comments are moderated before being published.

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.