Refurbished Filabot EX2 Extruder

  • Sale
  • Regular price $1,599.00

These refurbished systems were restored back to their former glory. They may have a few dents or scratches but the inside is as good as new. These systems come with a 90-day warranty. For any information please refer to the EX2 page.

Please note that we may not always have a refurbished system in stock and it is first come first serve when they are available.

Refurbished systems can't be applied to bundles nor can they be any further discounted. 

The Filabot EX2 system is our mid-level  extrusion system. The EX2 features a three-stage extrusion screw made from hardened and polished high-carbon steel. This proprietary, patent-pending screw  is designed to pressurize plastics during the extrusion process, assisting in diameter control and boosting the overall output. The mixing capability of the screw is enhanced by the utilization of a progressive compression section, which applies shear force between the polymer and the barrel wall. The EX2 also features extrusion speed control. The speed control board includes an automatic, variable voltage control module that is engineered to regulate the precise RPM of the screw as forces fluctuate in the extrusion process. When used with the Filabot Spooler, tolerances of +/-0.05mm can be achieved at a rate of 2 lbs an hour.

Extrudable Plastics: ABS, ABS Flame Retardant, 4043D PLA, 3D850 PLA, 3D870 PLA, PC, HIPS, PETG, and WAX. Lower Melt Flow Polymers

Extrusion Rate: Over 2 pounds of filament per hour (About 250 inches per minute using 4043D PLA @ 1.75mm)

Filament Sizes: 1.75mm and 2.85mm

Material Input Size: 1/8th of an inch pellets to powder

Material Capacity:  Hopper Volume - approximately 26 cubic inches
Screw Void - 1.75 cubic inches

Temperature Control: PID Controller, One Zone

Feed Screw and Drive:

0-35rpm Speed Control

85in lbs drive force

General Purpose Custom Designed Feed Screw

Non- Removable

Universal Power Input: 110 VAC or 220 VAC - 50 to 60hz - 500 watts

Physical Characteristics: Weight 28 lbs (12.7kg) and dimensions of 18in x 7in x 9in

90 Day Warranty

**Voltage Note - the 110VAC or 220VAC specific to the country that you are going to be using the extruder system in. There is no operational difference between the 110VAC or 220VAC.**

Click Here for the Filabot Extruder Manual

Click Here for the Ink Bird Temperature Control Manual

Below is a diameter of PLA filament that was extruded on a Filabot EX2 system. Tolerance is well within the +/- 0.05mm tolerance.

Reviews here